WSPR Setup - Station Parameters

6 posts / 0 new
Last post
KB3OMJ
Offline
Last seen: 1 week 20 hours ago
Joined: 2009/10/25 - 10:57
WSPR Setup - Station Parameters

I'm new to WSPR and seem to be having problems with station parameters. I started put using com1 and had no problems receiving. Upon checking the DOS window I got an error stating - "cannot open com1". So I went to com2 with the same results, still being able to receive. Changed to com3, and get no errors in the DOS window, still receive, but under the 'run date and time' there is nothing. No errors, but nothing else either. Is that the wy it should be or am I still having problems with correct setup.

One last question. Is there way way to check if my signal is going out? I look at the map specifically on 30m, see my callsign, colored lines connected to other callsigns, but how do you determine if those are contacts received or transmitted to?

73

Rich
KB3OMJ