CAT control problem for Flex-1500

6 posts / 0 new
Last post
PJ5_KJ6VW
Offline
Last seen: 8 years 4 months ago
Joined: 2010/11/20 - 13:43
CAT control problem for Flex-1500

I'm running v2.11 with a Flex-1500 using Eltima virtual serial ports and virtual audio cables on a Windows 7 64 bit computer. I set the Flex to ID as a TS-2000 and then as a TS-480 but could not get CAT control to work with either. CAT works fine with MARS-ALE, RMS Winmor, RMS Express, etc. Is this a known problem, or am I perhaps doing something wrong?

WSPR appeared to run fine otherwise (in receive only mode), but crashed after roughly 8 hours of continuous operation. PowerSDR was still running. Is this a known problem, or is it perhaps unique to my setup?