Hello ,
I have installed the new WSJT-X 1.4 beta but I can't get the cat Interface working.
I have got a messages "HamLib command rejected by the rig while setting VFO"
On the same PC, I have also installed WSPR 2.12 and that's working fine
Settings: WSPR 2.12
PTT methode CAT
Enable CAT yes
Rig Icom 306 IC-471
serial rate 19200
Data bits 8
Stop bits 1
Handshake Hardware -c 225 -r \\.\com11
Running VSPE before starting the perseus and WSPR program
I am running also the WSPR-X 0.8 r3058 with the following settings
PTT mode CAT
PTT port None
Enable CAT rig : Icom 306 IC-471
CAT port COM11
Serial rate 19200
Handshake none
Data bits 8
Stop bits 1
This setup is also working perfectly
When I start the WSJT-X program then a popup window appears
Rig Control Error
Do you want to reconfigure ....
settings under the radio tab are
Rig: Icom 471
serial port com 11
Data bits 8
Stop bits 1
Handshake Hardware
PTT methode VOX
Mode none
Split operation NONE
When I save the config and restart the application I am getting the same error
I have tried several rig configuration, but none of the configurations are working fine.
Please can somebody advise what to do.
Best regards,
Gerard
PD0GMU